So there I was ready to make up a final pair of trousers after the pattern had been altered, again. (I'm not ready to post the saga of getting from there to here as yet!) I realised they'd be a bit short after the extra crotch work that had been done. I reckoned I might get away with a tiny hem and they'd still be okay. In reality I thought they'd be another toile. Hopefully a wearable muslin. What's another toile between friends? I wasn't convinced that I could just jump from where I was to a final garment as there had been very major changes between the last toile that didn't fit too badly and this one.
The tops of the trousers were trimmed down in line with the marks previously made during fitting by Rory (with the addition of a seam allowance)
I pinned them together ready to sew but I realised I didn't have thread of a suitable colour or a suitable invisible zipper (I was going to do a side zip for this wearable toile). So I waited until the shops reopened after Easter and bought thread and a zip. The colours weren't perfect but zips come in a limited selection of shades. Good enough. I had a lot of other errands during which the zip fell out of my bag, David noticed and replaced it - but it wasn't there when I got home! No joy tracing it. No word in the days since. What would happen to a naked zip lying on the ground, after all?
I sewed up the trousers and overlocked the raw seam edges. Disaster! I accidentally caught and cut a 2” section at the front near the seam. I've put interfacing behind it and stitched over it but it's very obvious and these trousers are not wearable even as a wearable toile. Still, I had never really thought they would be.
 |
| The area cut by the serger |
I proceeded with the zip insertion which went okay. I actually had a suitable zip after all!
In reality, these trousers are not a good fit. I need to allow more room at my high hip - there was distinct pulling at that level. I've decided I do after all need to raise the front. I'll do trousers with a high waist, waistband and belt loops as I think that will suit my figure type better.
 |
| Lots of wrinkles Not good. The seams don't hang straight |
 |
| I've turned the facing up. That's a bit better |
 |
Front much too low. I do have a sloping waist but not by this much,surely?
The photos show both the low front waist and where I'm going to raise it to. I don't have photos with the belt before I marked it (what was going on today?)
Rory wasn't able to take the sewing bee today. Towards the end, I asked Dan to have a look at the trousers to see if she agreed about the pulling. She did and pinned out and photographed the extra needed, well the gap and measured it, and drew the darts in a better place - the back darts were decidedly wonky and pointing to the wrong place. The side seams are twisted (when they had been so good before!) but I'll make the other changes and leave this for the moment. Unfortunately only a couple of the photos taken have worked. Different phones!
|
 |
| I need this extra at the back mid seam |
 |
| I need this extra at the side high hip (2cms) |
